Directions for use

Unitor™ Commissioning Cleaner™ is for cleaning of new boilers and cooling systems on board new buildings. It will remove scale, rust, oil and grease at the same time from the systems. The product is recirculated through the system, using an external circulation pump.
Use the dosage 5-10% solution depending on the grade of contamination.

Degreasing and descaling of boiler and cooling water systems
The Unitor™ Chemical Cleaning Unit - Product no. 664 737189 - is recommended to be used.

1. Drain system to be cleaned if necessary.
2. Inspect as completely as possible to determine the extent of contamination and general condition of system.
3. Fill with fresh water.
4. Add a solution 5-10% strength of Unitor™ Commissioning Cleaner™.
5. Circulate through the system for 5 to 8 hours at the maximum temperature allowed by the system.
6. Drain system complete and flush thoroughly the entire system and all compounds with fresh water until effluent is clear.
7. Reinspect to determine results of the cleaning process.
8. If unsatisfactory, repeat steps 3 through 7.
9. Refill system with distillate or good quality fresh water and dose the required amount of cooling or boiler water treatment.
10. Test system on a regular basis to insure chemical residuals are maintained with specific limits.

产品特性

• 水性多功能清洁剂

• 可生物降解

• 不含壬基苯酚、聚乙氧基醇或相关激素成分

• 清洁用于轧制氧化皮，铁锈，油等的新系统

• 之后不需要中和化学品

优势

• 清洁水垢和薄油膜的水系统

• 通过钝化提供临时防腐蚀保护

• 铝，锌，锡及其合金的安全性

• 清洁后快速分离油

订购信息

Product number                           Product name

624932                                       COMMISSIONING CLEANER 25 LTR

使用说明

Unitor™ Commissioning Cleaner™ 用于清洁新建筑物上的新锅炉和冷却系统

。它可以同时去除系统中的水垢，铁锈，油脂。该产品是使用外部循环泵通过系统再循环
。

根据污染等级，使用5-10％的剂量溶液。

锅炉和冷却水系统的脱脂和除垢

建议使用Unitor™ Chemical Cleaning Unit - Product no.

664737189

1. 必要时清洗排水系统。

2. 尽可能完全检查以确定污染程度和系统的一般状况
。.

3. 加满淡水
。

4. 添加5-10％浓度的Unitor™Commissioning Cleaner™溶液。

5. 在系统允许的最高温度下循环通过系统5至8小时
。

6. 排空系统完成并用清水彻底冲洗整个系统和所有化合物，直至流出物澄清
。

7. 重新检查以确定清洁过程的结果。

8. 如果不满意

，请重复步骤3到7。

9. 使用馏出物或优质淡水重新填充系统

，并按照所需的冷却量或锅炉水处理量进行处理

。

10. 定期测试系统以确保化学残留物具有特定限制
。